Air has a really fast VPN system, and they have the best technical support I have ever seen. It's the reality and a lot of crazy things can bog them down. In that situation it's like it can't run or even walk because it's tripping over its own feet with every step. Set the MTU too high for a particular ISP's network, for example, and you can bring any VPN system to its knees, not because the VPN server is slow - it isn't - but because the network between you and that server is not getting packets to the server efficiently. Super poor vpn performance across many of a providers' servers is actually not indicative of a "bad vpn" (go stand in the corner!), but the technical settings in the software that will work for your situation can depend on many things, even the particulars of your ISP's service. None of my business, really, but as a member of the community who has used AirVPN daily for years and who has family and friends who have as well, and who is an engineer with decades of experience solving technical problems, I'm just going to interject that I am also offended by the OP's attitude that if something is wrong, surely it must be because someone is trying to cheat him. It's *vital* that users experiencing problems do report them upstream and provide reproducible steps (if possible).Īt the moment we still have a few "quite hard to reproduce" issues open and it'd be nice to receive any kind of input regarding them if you are experiencing the same. Regarding issues: if you have experienced anything that could be reported, please do so on GH in the issue page. So it should all be good for 6.3 as well! I just tested in this very moment whether it compiles on the latest netdev tree and it does. However, I think master compiles on 6.2 since a month at least. However, in the past few weeks we were focused on implementing some big and important changes, therefore we had to shift our effort a bit and could not work on compatibility with 6.1/6.2. Regarding compiling DCO, we normally strive to have it always compile on the latest kernel. The larger the user base, the faster we can find and squash bugs! Hi there, I am the main developer of the OpenVPN DCO kernel module and I am really happy to hear that you guys have been testing it out! You can check the status as usual in our real time servers monitor: ĭo not hesitate to contact us for any information or issue. Full IPv6 support is included as well.Īs usual no traffic limits, no logs, no discrimination on protocols and hardened security against various attacks with separate entry and exit-IP addresses and 4096 bit DH key not shared with any other VPN server. The server accepts connections on ports 53, 80, 443, 1194, 2018 UDP and TCP for OpenVPN and ports 167 UDP for WireGuard.ĭalim supports OpenVPN over SSL and OpenVPN over SSH, TLS 1.3, OpenVPN tls-crypt and WireGuard. The AirVPN client will show automatically the new server if you use any other OpenVPN or WireGuard client you can generate all the files to access it through our configuration/certificates/key generator (menu "Client Area"->"Config generator"). We're very glad to inform you that a new 10 Gbit/s server located in Alblasserdam (the Netherlands) is available: Dalim.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |